Tiny Arduino Board with mini-USB, 0.1" Pitch Pins, ATtiny85

Description

Tiny Arduino Board with mini-USB, 0.1" Pitch Pins, ATtiny85
OLIMEXINO-85-ASM
OLIMEXINO-85 is a small ready-to-use Arduino board complete with USB connector and available pins. It is based on the well-known Little Wire design which also is the basis of the Digistump's Digispark and Adafruit's Trinket. This board runs on the Digispark Arduino software.
It uses V-USB AVR emulation of USB with bit-banging, so although the ATtiny85 MCU has no USB port, the OLIMEXINO-85 actually does work as a
USB 1.1
device. It comes pre-programmed with the Micronucleus bootloader that can work with Digispark's Arduino distribution (this board does not work with the standard
Arduino IDE).
The eight pins broken out on the board are as follows:
#0
— PB0/MOSI/DI/SDA/AIN0/OC0A/#OC1A/AREF/PCINT0
#1
— PB1/MISO/DO/AIN1/OC0B/OC1A/PCINT1
#2
— PB2/SCK/USCK/SCL/ADC1/T0/INT0/PCINT2
#3
— PB3/PCINT3/XTAL1/CLKI/#OC1B/ADC3
#4
— PB4/PCINT4/XTAL2/CLKO/OC1B/ADC2
#RST
— PB5/PCINT5/#RESET/ADC0/DW
GND
— GND
VCC
— VCC
ATtiny85 Arduino Board Features
ATtiny85-PU microcontroller with pre-loaded Micronucleus Tiny85 bootloader
Tested and working out of the box with Digispark's Arduino distribution
Breadboard compatible via the headers
Two LEDs — power and status
Reset button
All components already soldered
Easy-to-replace components in case of fault
Open hardware — board schematics and layout available for Eagle
Open software — thanks to the Digispark community effort
Dimensions: 1.275 × 0.800 inches (32 × 20 mm)